vertical-line
Class Information for
IFGC, IPC, IMC, NEC Courses
button-background-13 button-background-14
button-underline
button-underline-pattern


Journeymen, Master Plumbers, Electricians, HVAC mechanics, and Gas Fitters are now required by the Virginia Board for Contractors to take a pre-determined number of continuing education hours specific to their trade as part of the licensing process.

Anyone obtaining or renewing a license must take continuing education in his/her respective profession. Plumbers, HVAC technicians and Electricians must take three hours of continuing education in their field. Gas fitters must take one hour. (This one-hour class for Gas Fitters is intended for Journeyman and Master Gas Fitters, Liquefied Petroleum Gas Fitters, and Natural Gas Fitters.)

Each course covers new definitions, code changes, general requirements, impacts on the job, general use and special equipment included in the respective codes.
 

Course Information

  • International Fuel Gas Code

    2012-IFGCThis seminar is based on the 2012 International Fuel Gas Code as adopted by the State of Virginia, DPOR.

    We will discuss the significant changes from the 2006 codes and the basic provisions for appliance installation, combustion air, venting, fuel gas piping, ducting, ventilation and exhaust. Participants will gain an understanding how these requirements apply to design, plan review and inspection

    This course is required to be taken by all fuel gas licensed tradesman in the state of Virginia once every two (2) years.

    This class is approved by the Virginia State Department of Professional and Occupational Regulation.

  • International Mechanical (HVAC) Code
  • International Plumbing Code
  • National Electrical Code
  • Code Books
footer947
vertical-line